Monitor Settings - Set Network Configuration

Installer Log In

Press the cog/settings icon in the top right and use '2012' as the passcode.

Press 'Advanced Settings' and then on the left press 'GSM'.

Now on the right side you can use the drop down button to select the correct 'GSM Config'.

For the changes to take effect there needs to be a reboot.

On the left panel select 'Power' and then press the 'Reboot' option. The system will now reboot.

You should now have a network connection.

Related Articles
Monitor Settings Menu - Serial Number
Access Settings Menu Hold down the lower brightness button and the hidden button to the left of it for 30 seconds or until the Settings Menu window pops up. Serial Number Location Use the Brightness buttons to move left and right and the hidden ...
Set USB Port Route
Atlas Firmware 1.2.3 or below Switch USB port routing to Atlas or Atom. The default logic is If not set to atom then route to Atlas. Default value: atom Options: atom, atlas Setting via TigerMX vars set usb_route atlas or vars set usb_route atom If ...
Reverse Split View Configuration
Reverse Split View Configuration What is it? When the vehicle is in reverse you will have the option to toggle between rear, left, and right views with the left and right chevrons. *If you can use "setReverseToggleLeftRight", this will do all the ...
Add Configuration Package to Installation
The recommended and most controlled way to update a vehicle configuration is through Universe's Configuration Package option. Admin -> Installation Find the installation that you'd like to apply the configuration update to then select the 'Settings' ...
Create Reverse Lines through Black Moth Monitor
Prerequisite Vehicle and Camera Measurements form filled out - attached. Configure Cameras Installer Login Begin by pressing on this ‘Settings’ icon in the top right corner. If this icon does not appear then the system requires an update. Contact ...