How to Install / Remove SmartMX Camera

How to Install / Remove SmartMX Camera

Turn off TigerMX-5 System

Follow this process to safely shutdown the system: How to Reboot / Shutdown / Hard Power Cycle

Removing and Installing SmartMX-180 Camera

1. Disconnect Camera

1.1. While holding onto the knurled (textured ridge) grip of the connector pull directly out away from the camera in a straight line. 
Do not try to unscrew or twist the connector. No tools are required. 
Knurled Grip
 
 Remove Camera
1.2. Unscrew the 4 screws holding the camera to the bracket. Retain the nuts/bolts/washers. 
Brace the camera so it doesn't fall. 
Camera Bracket (can vary)
1.3. Once removed store the camera on a flat surface with the camera lens facing up. 

2. Install Replacement Camera

2.1. Install the replacement camera onto the bracket using the nuts/bolts/washers from removal.
2.2. Push the connector in until it clicks.
Ensure the cable port is facing towards the ground. 
Installed Camera

Confirmation

1. Reconnect the TigerMX as per How to Reboot / Shutdown / Hard Power Cycle 
2. Turn the system on and confirm via the monitor touchscreen chevrons that the camera is now displaying. 

Contact support if further assistance is required: support@blackmoth.com


    • Related Articles

    • SmartMX Camera - Firmware Update Bug

      After updating to firmware 1.2.0+, the SmartMX camera may turn on at boot and then minutes later power off for no apparent reason, this could be a symptom of a firmware update bug.  If the Vehicle has been added to Black Moth Universe then a patch ...

    • SmartMX Camera Troubleshooting

      Software Check Before continuing with this guide first confirm the following: The camera view is not loading on the display (see below) The other camera views are working (use the on-screen buttons to check) Support has confirmed there's no software ...

    • TigerMX-5 - Install Replacement System

      Expected Time  20 minutes ​Prerequisite Screwdriver (type depends on the bolts used by the installer) Removal Process 1. Shutdown TigerMX-5 via Monitor If the system is currently online follow the 'Shutdown' section of this guide to turn off the ...

    • Camera view not rotating

      For when you've got a stubborn camera that is refusing to rotate.  Try to rotate the camera through the Monitor Settings (Settings > Basic Properties ) If the image is still not rotating then reboot the individual camaera. ssh root@$host ssh ...

    • SmartMX - Care Guide