Related Articles
SmartMX Camera - Firmware Update Bug
After updating to firmware 1.2.0+, the SmartMX camera may turn on at boot and then minutes later power off for no apparent reason, this could be a symptom of a firmware update bug. If the Vehicle has been added to Black Moth Universe then a patch ...
PCM Troubleshooting Guide
Pre-requisite Multimeter/Voltmeter Testing Measure the Output Voltage of the PCM at the OUT Terminals with a Multimeter/Voltmeter. If the Output Voltage is 13.5 (+/- 0.5V), the PCM is functionally operational. However, if the Output Voltage is low ...
SmartMX Camera Troubleshooting
Software Check Before continuing with this guide first confirm the following: The camera view is not loading on the display (see below) The other camera views are working (use the on-screen buttons to check) Support has confirmed there's no software ...
How to Install / Remove SmartMX Camera
Turn off TigerMX-5 System Follow this process to safely shutdown the system: How to Reboot / Shutdown / Hard Power Cycle Removing and Installing SmartMX-180 Camera 1. Disconnect Camera 1.1. While holding onto the knurled (textured ridge) grip of the ...
TigerMX Harddrive (SSD) Replacement - How-to Guide
Overtime SSDs can become subject to wear and tear preventing data from being stored. It can be replaced without sending the TigerMX back. The SSD is found on the underside of the TigerMX, so it must be removed to expose the SSD. d Removing the ...